Fast-mount wire holders
Published: 26 March, 2019
CONTA-CLIP has further enhanced its range of usability aids for VK cabling ducts, adding fast-mount wire holders. The wire holders can be clipped into the cabling ducts without tools. The company says they make it easier to neatly arrange conductors and keep signal and power lines clearly apart and they also simplify adding new wiring, since existing cables stay put and do not come lose and entangled when the cover is removed and last but not least, users will find it easier to clean their well-organised cabling duct of dust.
The wire holders are available in two versions. The DHG type holder has closed spring brackets – cables can be pushed in from above. It comes in three sizes: 34 x 35 mm, 34 x 53 mm and 53 x 75 mm.
t: +49 . 5257 . 9833 - 0
e: christian.quade@conta-clip.de
Click here for the full unedited version of the release as provided by the company
CONTA-CLIP says accompanying the KDSClick cable entry system, it supplies easy-to-install, galvanised EMC rails for safe and secure shield termination of cables. KDS-EMV-SAB type rails are attached to the KDSClick mounting screws inside control cabinets and secured with a nut.
STERTIL says following the successful use of three of its fast-action FlexiEdge doors for over ten years, Glatfelter Lydney has specified an additional five doors to help improve hygiene and working conditions within various areas of its manufacturing facility.
